How Does a Magnetic Flowmeter Work?

The Short Answer

A magnetic flowmeter creates a magnetic field across the pipe. When a conductive liquid flows through the field, it generates a small voltage that is directly proportional to its velocity. Electrodes pick up this voltage, and the meter converts it into a flow rate. There are no moving parts and nothing obstructs the flow.

Faraday’s Law in Action

Faraday’s law of induction states that a conductor moving through a magnetic field generates a voltage. In a mag meter, the conductor is the liquid itself. Coils on the outside of the flow tube create the magnetic field, and two electrodes in the pipe wall measure the induced voltage.

Induced voltage = Magnetic field strength × Flow velocity × Pipe diameter

Because the field strength and diameter are fixed, the voltage depends only on velocity. Multiply velocity by the pipe area and you have the volumetric flow rate.

What Mag Meters Can Measure

Advantages and Limitations

Advantages

Limitations

Installation Tips

Related Products

We supply inline magnetic flowmeters and the displays and totalizers to go with them.

Magnetic, ultrasonic and turbine flow sensors. View range

Rate meters, totalizers and batch controllers. View range

Display flow rate from a 4-20 mA signal. View range

Frequently Asked Questions

No. Oil is not electrically conductive, so a mag meter cannot generate a signal. Consider a turbine, gear or ultrasonic meter instead.

Less than most technologies, but a few diameters upstream and downstream improve accuracy.

Most mag meters need at least 5 µS/cm. Some special designs work down to lower values.

More in This Category

How Does a Clamp-On Ultrasonic Flowmeter Work?

A clamp-on ultrasonic flowmeter fixes two transducers to the outside of the pipe. They take turns sending ultrasonic pulses through the pipe wall and liquid, one with the flow and one against it. The pulse traveling with the flow arrives slightly sooner. The meter measures this transit-time difference and calculates the flow velocity, without cutting into the pipe.

How Much Straight Pipe Does a Flowmeter Need?

Most flowmeters need a length of straight pipe before and after them, measured in pipe diameters (D). A common rule of thumb is 10D upstream and 5D downstream, but the real figure depends on the meter type and on what sits upstream. Magnetic meters can need as little as 5D, while turbine and ultrasonic meters can need 20D or more after a valve or pump.

Need help choosing the right product?

Our engineers can help you select, configure and integrate the right sensor, instrument or industrial computer for your application.