How Do I Convert 4-20 mA to 0-10 V?

The Short Answer

The reliable way to convert 4-20 mA to 0-10 V is with a signal converter, which scales 4 mA to 0 V and 20 mA to 10 V and isolates the two circuits. A 500 Ω resistor across the input gives 2-10 V, not 0-10 V, so the receiver must be scaled to match, and there is no isolation. A 250 Ω resistor gives 1-5 V for inputs that accept it.

Option 1: A Resistor

Ohm’s law turns current into voltage. Placing a precision resistor across a voltage input converts the loop current into a voltage:

Voltage = Current × Resistance

250 Ω

4-20 mA becomes
1-5 V

500 Ω

4-20 mA becomes
2-10 V

This is inexpensive but limited. The output never reaches 0 V, the resistor adds to the loop burden, the receiver must be rescaled, and there is no isolation, so ground loops remain a risk.

Option 2: Reconfigure the Input

Many PLC and controller inputs can be switched between current and voltage modes. If your input supports 4-20 mA directly, use it. Changing the receiver is often simpler than converting the signal.

Option 3: An Isolated Signal Converter

A signal converter receives the 4-20 mA signal and outputs a true 0-10 V signal, with full scaling from 0 V at 4 mA to 10 V at 20 mA. It also galvanically isolates the input, output and power supply, which removes ground loop problems and protects both devices.

Choosing a Converter

Related Products

Our signal converters cover 4-20 mA, 0-20 mA, 0-10 V, 0-5 V and 1-5 V, with sink and source outputs.

Isolated 4-20 mA to 0-10 V converters. View range

Display any analog signal in real units. View range

Analog inputs for current and voltage. View range

Frequently Asked Questions

Yes. Signal converters work in both directions. A 0-10 V input to 4-20 mA output converter lets voltage sensors drive long cable runs.

A 500 Ω resistor turns 4 mA into 2 V. Scale the receiver for 2-10 V, or use a signal converter for true 0-10 V.

Most do, typically 24 VDC. Some loop-powered isolators take power from the 4-20 mA loop instead.

More in This Category

What Is Galvanic Isolation, and Why Does It Matter?

Galvanic isolation separates two electrical circuits so that no current can flow directly between them, while the signal still passes across. Isolators do this with a transformer, an optocoupler or a capacitive barrier. In instrumentation, isolation removes ground loops, blocks common-mode noise, and protects control equipment from surges and faults in the field.

Need help choosing the right product?

Our engineers can help you select, configure and integrate the right sensor, instrument or industrial computer for your application.