Knowledge Hub

Signals & Communication

How analog signals like 4-20 mA and 0-10 V work, how to wire them, and how digital protocols such as HART, Modbus, RS-485 and IO-Link carry sensor data.

Articles in This Category

2-Wire vs 3-Wire vs 4-Wire Transmitters: What Is the Difference?

All three transmit the same 4-20 mA signal. The difference is how they get power. A 2-wire transmitter draws its power from the signal loop itself. A 3-wire transmitter has a separate supply wire and shares a common return with the signal. A 4-wire transmitter has completely separate power and signal pairs, so it can use much more power, including AC mains.

4-20 mA vs 0-10 V: Which Analog Output Should You Choose?

Choose 4-20 mA for long cable runs, electrically noisy plants and anywhere you need to detect a broken wire. Choose 0-10 V for short runs inside a panel or machine, where its simpler wiring and direct compatibility with many controllers and drives are an advantage.

Modbus RTU vs Modbus TCP: What Is the Difference?

Modbus RTU and Modbus TCP use the same registers and function codes. The difference is how messages travel. Modbus RTU sends compact binary messages over a serial link, usually RS-485. Modbus TCP wraps the same messages in TCP/IP packets and sends them over standard Ethernet.

What Is a 4-20 mA Signal?

A 4-20 mA signal is an analog DC current that represents a measured value, with 4 mA at the bottom of the range and 20 mA at the top. Because it is a current rather than a voltage, it travels long distances without losing accuracy, and the same two wires can power the sensor.

What Is a Ground Loop, and How Do I Prevent One?

A ground loop happens when a signal circuit is connected to ground at two or more points that are at slightly different voltages. The difference drives an unwanted current through the signal wiring, which shows up as offset errors, noise or drifting readings. The cure is to break the loop with galvanic isolation or to ground the circuit at one point only.

What Is HART, and How Does It Work Over a 4-20 mA Loop?

HART (Highway Addressable Remote Transducer) is a digital protocol that rides on top of a standard 4-20 mA signal. It superimposes a small, high-frequency signal on the loop current, so the analog value keeps working while a HART device can also exchange configuration settings, diagnostics and extra measurements over the same two wires.

What Is RS-485, and How Do I Wire and Terminate It?

RS-485 is a differential serial standard that sends data as the voltage difference between two wires, usually labeled A and B. That makes it highly resistant to noise and lets one twisted pair link up to 32 standard devices over about 4,000 ft (1,200 m). For reliable communication, wire the devices in a daisy chain and fit a 120 Ω terminating resistor at each end of the cable.

Can't find the answer you need?

Ask our engineers. We can help you select, configure and integrate the right product for your application.