Knowledge Hub

Vibration & Machine Monitoring

Accelerometers, IEPE sensors and eddy current proximity probes for condition monitoring, including mounting, sensitivity selection and API 670 systems.

Articles in This Category

How Do I Choose Accelerometer Sensitivity (100 mV/g vs 500 mV/g)?

Use 100 mV/g for most general machinery, such as motors, pumps and fans. Choose 500 mV/g or higher for slow-speed machines and very low vibration levels, where you need more signal above the noise floor. Choose 10 mV/g or lower for high-amplitude vibration and shock, where a sensitive sensor would saturate.

How Does a Piezoelectric Accelerometer Work?

A piezoelectric accelerometer contains a small mass resting on a piezoelectric crystal. When the machine vibrates, the mass presses on the crystal with a force proportional to the acceleration, and the crystal produces a matching electrical charge. Built-in electronics convert this charge into a voltage signal, typically 100 mV per g, that represents the vibration.

How Should I Mount an Accelerometer? Stud, Adhesive and Magnet Compared

Stud mounting to a flat, spot-faced surface gives the best high-frequency response and is the choice for permanent installations. Adhesive mounting to a mounting pad is a good alternative where you cannot drill. Magnet mounting is quick and suits portable data collection, but it limits the usable frequency range.

What Is API 670? Machinery Protection Systems Explained

API 670 is the American Petroleum Institute standard for machinery protection systems. It defines how vibration, axial position, speed and temperature are measured and monitored on critical rotating machines, such as turbines, compressors and large pumps, so that a fault trips the machine before it causes catastrophic damage.

What Is IEPE (ICP), and How Is an IEPE Sensor Powered?

IEPE (Integrated Electronics Piezo-Electric) describes a vibration sensor with a built-in amplifier that is powered and read over the same two wires. The input supplies a constant current, typically 2 to 10 mA, from an 18 to 30 V source. The sensor sits at a DC bias voltage of around 10 to 12 V, and the vibration signal rides on top of it. ICP is a trademarked name for the same technology.

Can't find the answer you need?

Ask our engineers. We can help you select, configure and integrate the right product for your application.